How to install Pterodactyl Wings

So you have finished the installation of the panel and you want to actually be able to run servers on it! In this article we will explain how!

This is the last part out of the pterodactyl series.

1. You should have been left at the message "Installation of panel completed. Do you want to proceed to wings installation? (y/N)" type "y"and press enter. It will ask you if you want to automatically setup UFW firewall, type "y" and press enter. On the next question answer "n"and enter.
2. It will ask you Do you want to automatically configure HTTPS using Let's Encrypt? (y/N) depending on if you are using a domain answer yes or no. If you dont know what to pick basically, without a domain pick no with a domain pick yes. then type "y" and enter to proceed with the installation.
3. Wings should have succesfully been installed.
4. head over to the domain or ip you have installed pterodactyl on. You should be greeted by image below, just go ahead and sign in.

5: Follow the steps SUPER carefully in the next video